U2714 BMW Fault Code

Description:

Brake Switch Circuit Input Malfunction Indicates PCM did not receive a brake pedal position (BPP) input. Open or short in BPP circuit Open or short in stoplamp circuits damaged PCM Malfunction in module(s) connected to BPP circuit.

(Rear Electronic Module [REM] Windstar and LS6/LS8 or Lighting Control Module (LCM) Continental and Town Car. Damaged brake switch Misadjusted brake switch Check for proper function of stoplamps.

U2714 Code Symptoms :

There are currently two main types of cylinder deactivation used today, depending on the type of engine. U2714 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.

Diagnosis And Repairing U2714

U2714 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix U2714 code ?

• Damaged ECM
• Camshaft advance mechanism binding (VCT unit)
• EVAP system hose leaking
• Improper ignition timing

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U2714, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code U2714 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.